How to Fix Damaged Hard Disk
If your hard disk suddenly damaged, depending on the level of damage, you can fix it up back to normal or merely to save important data is aja. And depending on your choice, may need to be cannibals several components. Here are some guidelines that you can make reference.
The most common problem comes from the damage to the master boot record, FAT, or directory. That this is a minor problem that normally would be improved by using a utility such as Fdisk / mbr to refresh the master boot record and then reboot and continue with Norton Disk Doctor.
Hardware problems are the most common problem of controller damage, damage to the drive motor, or mechanical interference problems on your hard disk head.
First check whether the BIOS can recognize and correctly identify the hard drive.
If not, then the controller onboard hard disknya damaged.
Check whether the hard disk spinning and spinning with a constant velocity.
If yes means motor functioning.
If your hard drive like crazy and then suddenly died, the most likely culprit is a bad controller.
Possible current to the motor affected hard disk and hard disk may need a new controller.
Did you hear a lot of noise when cletak-cletek computer just turned on (but before the system tries to access the hard disk).
This sounds like the coil Bearings shown that it is loose and worn. It may even be up there rocking here.
In the case of damage to software, each utility to repair has its own uniqueness. Often times, Norton Disk Doctor will go too far (if you leave). It is better if you improve the use of this utility as per step, bit by bit and then check to see if we can copy the data. Save the data first for the hard disk can be accessed, while continuing to try to fix it. In Norton, this utility can to change the name of directories and files, and even delete it or breaking it into fragments that does any good.
, jalankan Fdisk dan periksa apakah Fdisk dapat mengenali partisi pada harddisk." onmouseover="this.style.backgroundColor='#ebeff9'" onmouseout="this.style.backgroundColor='#fff'">If disknya spinning hard, try to boot to the prompt A>, run Fdisk and check to see if Fdisk can recognize the partition on the hard drive. If Fdisk can recognize the partition, this means that he can access the drive and that its electronic controller to function properly. If no sound cletek-cletek, maybe the problem is only on the usual bad sector occurs when there is conflict in your computer's power supply power from the excess. These things usually happen when a loss of the master boot record, file allocations table, and the primary directory. With Fdisk can fix your master boot record and with your Norton Disk Doctor can restore the FAT and Directory from the secondaries.
Hard disk spinning but Fdisk does not recognize it. Try this hard disk on another computer and repeat the test to confirm that Fdisk can not read through the onboard hard disk controller. If the hard disk on another computer readable, then the hard disk interface in your CPU is damaged. You can upgrade or replacement of control card such as Promise or CMD Technologies (there are others) on your computer after turning off the integrated controllernya in BIOS, but if you've got controllernya integrated, maybe it was a sign of damage again in the future and You had better get to replace the motherboard. Trying to drive in another machine also eliminates the possibility that the power output of 12 volt your CPU is damaged.
If your hard disk noise but cletak-cletak constant motor rotational speed, (not corrugated), you can try to put the disk in the freezer for about 12 hours. This is an old trick from when its time driver MFM / ESDI, when om Otong was young. The idea is to create a component shrinking hard disks that fit the marker track position again with the hard disk tracks. At the present time is actually rare case may be, but in the past, balancing and Bearings has not been so good. However, for the circumstances we're dealing with this, maybe this old trick cukupmembantu. Depending on how long the age of the hard disk and how many hours of useful life, if your hard disk can diakse then you have to be quick to copy the data. Nah kalo in earlier times, when hard disk capacity is much smaller, so the data need to be copied is not so much. In our case, copy the important data first yes.
Hard disk does not spin. Both onboard controller and the motor is faulty (assuming you do not try it on another computer). Here, if the data in your hard disk so important to be saved, then it's time to spend your hard disk: D. You should find the same hard disk model exactly. If you can find the same hard disk, start with the replacement / exchange controller, because this is the simplest thing to do. If the exchange controller does not generate as you wish, you can open the hard disk and swap motorcycle. When you open a second hard disk, you can likewise observe platters, heads and armaturesnya. You may even be noticeable this disk to the CPU and turn on your CPU. This way, you can see if there was something different between the two hard disks when accessed CPU. Exchange patters may not be much use. Because it is basically like a balanced system in your car tires, and I suspect that each hard disk will vary with the other hard disk.
0 komentar:
Posting Komentar